OSDP Requirements for PremiSys

OSDP Requirements for PremiSys

What Is OSDP?

Open Supervised Device Protocol (OSDP) is an access control communications standard developed by the Security Industry Association (SIA) to improve interoperability among access control and security products.  OSDP is a bi directional that communicates between the Access control reader and the access control panel. The communication is bi-directional to allow clock updates, or tamper detection in the wire run.

Premisys Software Requirements: You must be running PremiSys version 4.0.1043 or higher in order to utilize OSDP readers.

Mercury Hardware Support:

Mercury first supported OSDP version 0.9. This was available on the MR50 (series 2), MR52 (series 2), MR51e, EP1501 onboard reader ports, and EP1502 onboard reader ports. The MR51e, EP1501 onboard reader ports, and the EP1502 onboard reader ports have been updated to support OSDP v.2.1.6 and v2.1.7 The table below is the earliest recommended versions to use, additional updates may have been made in later versions, so check to see if a newer version is available. Earlier versions started supporting the updates to OSDP, but may not have all the required pieces in place.

Device

OSDP v2.1.6

w/Secure Channel OSDP v2.1.7

MR51e

1.5.4 fw

1.5.9 (Requires boot 1.1.4)

EP1501 Onboard Reader Ports

1.19.8

1.20.1

EP1502 Onboard Reader Ports

1.19.8

1.20.1

MR50 (Series 3)

All

All

MR52 (Series 3)

All

All

MR62e

All

All

LP Series Controllers

All

All

 

Panel Requirements: The following panels have support for OSDP with in PremiSys.

LP - 1502 (2 Reader Controller Red)

LP-1501 (PoE One Door Reader Controller Red)

LP-2500 (IP Controller Red) Note: This controller does not have reader ports. It does however support downstream I/O boards (MR-52 S3 & MR-50 S3.)

EP-1502 (2 Reader Controller Green)

EP-1501 (PoE One Door Reader Controller Green)

MR-52 Series 3 (Two Reader Board Series 3 Red)

MR-50 Series 3 (One reader Board Series 3 Red)     

MR62e Series 3 (PoE One Door Reader Board Series 3 Red) Note: This panel only supports OSDP readers. You cannot use traditional readers on this panel.

The following is an overview of OSDP V2 support on Mercury Panels:

Capability

LP1501

LP1502

MR50-S3

MR52-S3

MR62e

EP1501

EP1502

MR50-S2

MR52-S2

MR51e

Secure Channel

X

X

X

X

 

X

Biometric Reader Support

X

X

X

X

 

 

OSDP Mfg Specific Pass-Through Support

X

X

X

X

 

 

 

 Reader Requirements: You must use a reader that has support for OSDP.

A few examples of OSDP compliant readers (HID  R30, HID R40, HID RK40)  (Schlage MT11, Schlage MT15, Schlage MTK15, Schlage MTMS15)

Reader addressing selectable between 0 and 3

Configurable baud rate for 9600, 19200, 38400, 115200.

 


How Did We Do?


Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)