Upgrading LP Controller Firmware through the Configuration Manager
1.) If you have a user account set up on the controller, continue to step 3.
2.) If you do not have an account set up on the controller, you will have to go to the controller's physical location and turn Dip Switch 1 to the ON position. You have 5 minutes to log in to the browser interface after moving DIP Switch 1 to the ON position.
3.) Log in to your controller’s IP address through a web-browser.
4.) Default Username = Admin; Default Password = password
5.) Click the Device Info link on the left-hand side. Look for Firmware Revision: this will show the current firmware loaded on the controller.
6.) Click the Diagnostic Link on the left-hand side.
7.) Click Choose file to browse to your firmware file. It will show the firmware file you selected.
8.) Click load file to begin the firmware upgrade process. This will show the status of loading file. The status then goes to Installing.
9.) When the file is completed, you will see a box when you loaded the file goes to a not responding state.
10.) The firmware is now loaded. Log into the controller again and click the Device Info button and make sure it has the correct firmware version you just loaded.
